How to install cement backer board behind a bath tub? - bath board
Cut out the area where the plates will be the basis poles. Cut the size of the tiles and the sink with 5 / 8 drywall screws or 3 / 4 inches
Sunday, January 24, 2010
Bath Board How To Install Cement Backer Board Behind A Bath Tub?
5 comments:
regular work is usually drywall screws. not to break the board Backer much, but you still need something to be sunk.
must draw the bath, disconnect the water supply - drain - you move the tub from the wall and then put in the party of the Council, then drag it onto the tank and allow to enter drains rehook. I hope the leak will move more than half an inch, again readjust.
Why else behind the bathtub? Need advice trailers behind the tiles - no tiles behind the bath. So, now cut drywall on the wall above the tub and replace it with the grinding room. The results are now "tile" a lot easier, faster, and the same.
must draw the bath, disconnect the water supply - drain - you move the tub from the wall and then put in the party of the Council, then drag it onto the tank and allow to enter drains rehook. I hope the leak will move more than half an inch, again readjust.
Why else behind the bathtub? Need advice trailers behind the tiles - no tiles behind the bath. So, now cut drywall on the wall above the tub and replace it with the grinding room. The results are now "tile" a lot easier, faster, and the same.
If you support the installation of slabs tiles do first is about 4 thousand sheets of plastic poles in the bathtub is on the seams, the installation of the bathtub. then put the plate in the plastic above the upper edge of the tub. Buy screws (not on the base plate are made drywall screws). Once installed, the Council Backer, use a nylon joint tape Backer Board also develops and then apply thinset joints.
Operation is like the dry stone walls
Post a Comment